Maxos TL-D IP64 electrical units – Protection plus

Maxos, TL-D IP64 electrical units

Maxos, TL-D IP64 electrical units

Product family information

The IP64 electrical units are designed for quick and reliable mounting in Maxos IP64 light-line sections. They are made of steel with a white powder finish. The high IP classification is possible due to special seals between the light-line sections and to lamp holders with gasketted screw rings on the IP64 electrical units. Maxos IP64 is not designed for application in regular humid environments.A connector block is mounted for electrical connection to the light line. The electrical units are equipped with electronic ballasts (including dimmable and DALI) or low-loss conventional ballasts. The conventional ballasts are available as inductive, parallel compensated (IC) or inductive (I). The units can hold 1 or 2 TL-D lamps.Dimmable versions are delivered with HF-R electronic ballast, allowing the light output of the TL-D lamps to be regulated from 3 to 100%. HF-R and HF-DALI units must be mounted to 7-wire light-line sections.The electrical units can be combined with dedicated IP64 trapeze reflectors and a selection of aluminum reflectors. These aluminum reflectors offer a choice of narrow-beam, asymmetrical-beam and very-narrow-beam light distributions for 1 x 58 W. Units which comply with the FF rules (limited surface temperature) are available on request.Special electrical units equipped with an emergency battery pack for 1 or 3 hours (EL1/EL3) are available. These units must be used with 7-wire light-line sections.




Protection tubes
Trapeze reflectors (1-lamp) or dedicated IP64 trapeze reflectors
High ingress protection keeps out dust and moisture
IP64 solutions for system including trunking
Units which comply with the FF rules (limited surface temperature) are available on request.


See all products
Software Plugins
Product family details
  • 4MX091
Light source
  • Fluorescent:
  • 1 x or 2 x MASTER TL-D / G13 / 36, 58 W
  • Electro magnetic (low loss), 230 or 240 V / 50 Hz:
  • Inductive (I)
  • Inductive, parallel compensated (IC)
  • Electronic, 220 - 240 V / 50 - 60 Hz:
  • High Frequency Performer (HFP)
  • High Frequency Regulator (HFR)
  • Emergency lighting:
  • 1 hour (EL1), 3 hours (EL3)
  • Sheet steel in white (WH)
  • Protection tube
  • Not for permanent wet conditions, corrosion possible over time
  • To be used with standard trapeze reflectors (1-lamp) or dedicated IP64 trapeze reflectors (2-lamp) or dedicated aluminum reflectors (on request)
  • Check a product to add
  • Check a product to add
  • Check a product to add
Check a product to add

Cannot find what you're looking for?
Perhaps one of these links might help

Contact us   
Distributor or partner finder